Forged 355 LT1 Build - SoFlaSportbikes.com

XtremeOracing · 05-13-2010, 12:03 AM

I am almost done with my camaro's engine build. Forged 355CiD LT1 H/C/I + Nitrous Motor. Here are some pics

LT1 4 Bolt Main Block

Speed Pro Forged Pistons

SFI 18.1 Race Damper

Roll-cage Install

Some more misc pics.

Engine Before Rebuild

Nitrous!

R1BULLET · 05-13-2010, 04:08 AM

what shot are u running?

XtremeOracing · 05-13-2010, 09:55 AM

Quote:

Originally Posted by 92gsxr750

what shot are u running?

2 Stage 175.

relentless · 05-14-2010, 01:13 PM

I place my rear bars on the 6 point the same way. I found out later it was bad when i went to 28" tires and had to go through the doors to put them in the back.

XtremeOracing · 05-14-2010, 02:43 PM

Quote:

Originally Posted by relentless

I place my rear bars on the 6 point the same way. I found out later it was bad when i went to 28" tires and had to go through the doors to put them in the back.

Yea i didn't exactly like the way they came out either, next time i'm going to buy the cage pre-bent and cut. All the bending, cutting and notching was a pain the

XtremeOracing · 07-08-2010, 11:17 AM

Update on the block!

SICKNOUZA · 07-08-2010, 11:30 AM

nice setup. what is your end goal for the car?

buzzcutt2 · 07-08-2010, 11:33 AM

I wanna go fast

XtremeOracing · 07-08-2010, 11:34 AM

Quote:

Originally Posted by atlantabraves707

nice setup. what is your end goal for the car?

Well it was going to be a street/strip car; but i am in the process of removing all climate control stuff and audio stuff and seeing what else i can remove to lighten it up.

As far as the motor its got all forged bottom end and a 600 lift cam setup for nitrous. Going with some LE2 heads. Should be able to pull low 11s until my 10bolt rear end blows! Then with a 12 bolt i should be able to pull some 10s.

SICKNOUZA · 07-08-2010, 11:36 AM

Quote:

Originally Posted by XtremeOracing

Well it was going to be a street/strip car; but i am in the process of removing all climate control stuff and audio stuff and seeing what else i can remove to lighten it up.

As far as the motor its got all forged bottom end and a 600 lift cam setup for nitrous. Going with some LE2 heads. Should be able to pull low 11s until my 10bolt rear end blows! Then with a 12 bolt i should be able to pull some 10s.

what gears do you have? what have you done suspension wise to support this power? what tranny are you going with? i like the build. i have always been a fan of and done all motor with nitrous builds in my cars